Electrical, mechanical and plumbing, wherever your project is +1 407-751-1755WhatsAppTeams callLinkedIninfo@mep.symateq.com

Contractors support

Shop drawings, coordinated models and as-built records from Revit, prepared for the way you build.

Tower cranes over a commercial building site at dusk

In shortSYMATEQ supports contractors by preparing shop drawings and fabrication models from Revit, running clash detection and coordination in Navisworks, and producing scan-to-BIM and as-built models. Drawings and models are prepared for review and issue by the project's licensed engineer.

Who this is for

This page is for general contractors who need coordinated drawings and models to build from: shop drawings, trade coordination and a record of what was installed. You send the design set, your markups and the site information. We return drawings and models.

What we do

  • Shop drawings and fabrication models from the Revit model
  • Clash detection and trade coordination in Navisworks
  • Scan-to-BIM and as-built models
  • Revisions from your Bluebeam markups as the job changes
  • Electrical, mechanical and plumbing drawings in your format

What you send

  • The design set and the architect's model
  • Your markups and site changes
  • Your fabrication or drawing standards

What you get

  • Coordinated shop drawings and models
  • Updated sets as markups come in
  • A date and a price before work starts

Where it is offered

What we prepare depends on your region. Each region has its own support page.

United StatesDesign assist and calculations for electrical, mechanical and plumbing, fire protection and fire alarm design assist, COMcheck, permit-ready lighting reports, drafting and Revit modeling.
CanadaMEP design assist with calculations, permit-ready lighting reports, drafting and Revit modeling.
Australia and New ZealandElectrical design assist and calculations, permit-ready lighting reports, and drafting and Revit modeling for electrical, mechanical and plumbing.
United Kingdom, Ireland, Netherlands, Finland, Middle EastMEP drafting, Revit modeling and DIALux and AGi32 lighting models.

How a job runs

  1. Discovery and consultation

    A short conversation about the project, the deadline, the codes and what matters most to you. No obligation.

  2. Scope and onboarding

    You get a clear scope, timeline and price. We sign an NDA if you need one, set up secure file transfer and take on your Revit and CAD templates and layer standards.

  3. Engineering and modeling

    We do the design assist, calculations, drawings and Revit models, built to the codes of your region.

  4. Coordination and QA/QC

    We coordinate the trades in Navisworks and check the set against a QC list before it leaves us.

  5. Delivery and support

    You get clean, coordinated, permit-ready sheets on the agreed date, with quick turnaround on revisions.

Questions about contractors support

How fast are revisions?

Markups and small revisions are typically back within one business day. Larger packages get a date from us before we start.

Do you install or fabricate?

No. We prepare the drawings and models. Installation and fabrication stay with you and your trades.

Reviewed by the SYMATEQ team. Last reviewed: 16 November 2026

Start a project

Have a project in mind?

Tell us the discipline, the code and the deadline. We reply with a price and a date, usually within one business day.

Used only to reply to you. Privacy