Design assist support
We prepare the layouts, the calculations and the drawings. Your licensed engineer reviews, seals and issues them.

In shortDesign assist at SYMATEQ means we prepare layouts, calculations and drawings for your licensed engineer to review, seal and issue. It is offered for electrical, mechanical and plumbing in the US and Canada, for fire protection and fire alarm in the US, and for electrical in Australia and New Zealand.
Who this is for
This page is for engineers and firms deciding what to hand over. Design assist is the part of the work that sits between your design intent and the final drawings: the loads, the sizing and the layouts, written out so you can follow and check them. Responsibility for the design stays with your firm.
What we do
- Layouts and sizing to the code edition the project is under
- Calculations written out step by step
- Drawings and Revit models that come from them
- Lighting layouts and photometric models
- Revisions after your review
What you send
- Your design intent and any markups
- The code and edition the project is under
- Your template and standards
What you get
- Calculations and layouts for your review
- Drawings and models in your template
- A scope, a date and a price before work starts
Where it is offered
What we prepare depends on your region. Each region has its own support page.
| United States | Design assist and calculations for electrical, mechanical and plumbing, fire protection and fire alarm design assist, COMcheck, permit-ready lighting reports, drafting and Revit modeling. |
| Canada | MEP design assist with calculations, permit-ready lighting reports, drafting and Revit modeling. |
| Australia and New Zealand | Electrical design assist and calculations, permit-ready lighting reports, and drafting and Revit modeling for electrical, mechanical and plumbing. |
| United Kingdom, Ireland, Netherlands, Finland, Middle East | MEP drafting, Revit modeling and DIALux and AGi32 lighting models. |
How a job runs
Discovery and consultation
A short conversation about the project, the deadline, the codes and what matters most to you. No obligation.
Scope and onboarding
You get a clear scope, timeline and price. We sign an NDA if you need one, set up secure file transfer and take on your Revit and CAD templates and layer standards.
Engineering and modeling
We do the design assist, calculations, drawings and Revit models, built to the codes of your region.
Coordination and QA/QC
We coordinate the trades in Navisworks and check the set against a QC list before it leaves us.
Delivery and support
You get clean, coordinated, permit-ready sheets on the agreed date, with quick turnaround on revisions.
Questions about design assist support
Is design assist the same as engineering?
No. Design assist is preparation for your licensed engineer, who reviews, seals and issues the final drawings. Responsibility for the design stays with your firm.
Where is design assist offered?
For electrical, mechanical and plumbing in the US and Canada, for fire protection and fire alarm in the US, and for electrical in Australia and New Zealand. Everywhere else we offer drafting, Revit modeling and lighting models.
Related support
Engineers support
You keep the design and the seal. We prepare the drawings, the models and the calculations in your templates, ready for you to check.
OpenElectrical support
Power distribution, lighting and photometrics, low-voltage, solar PV and EV charging, with the scope set by your region.
OpenMechanical support
Heating and cooling loads, ducts and ventilation, equipment schedules and Revit mechanical models, with the scope set by your region.
OpenPlumbing support
Fixture counts, water, drainage, vent and gas, risers and Revit plumbing models, with the scope set by your region.
OpenReviewed by the SYMATEQ team. Last reviewed: 16 November 2026